Differences

This shows you the differences between two versions of the page.

--- namespace:chiller_flush [2026/02/20 17:33] – admin
+++ namespace:chiller_flush [2026/08/05 16:47] (current) – 12.144.223.107
@@ Line 1: / Line 1: @@
 =====Inlite Chiller and Recirculator Flush=====
+**LAST REPLACED DI FILTER: July 31st 2026**
 There are times when the Inlite laser head will decrease in energy, as well as needing to replace filters.\\ This should help as a guild so doing these tasks go smoothly and quickly.
@@ Line 10: / Line 12: @@
 If you want to clean the system. Let a solution of 80% Hydrogen Peroxide and 20% distilled water run overnight. You can leave in Standby mode for this time.
+The next morning, pump out all the Solution out and clean with distill water. Then fill the reservoir.
+Actually Steps:
+  - Turn Off the chiller, by the switch and the key
+  - Open the interlock top cover
+  - Use the yellow pump to Syphin the water OUT of reservoir
+  - Unplug the Return line, from the back of the rack, (have 1-2 paper towels ready for a few drops)
+  - connect the pump to the return hose and syphon the water out of the laser head.
+  - Fill with 80% Hydrogen peroxide 20% distilled water(2 normal size bottles were enough,)
+  - you will need to close the interlock and turn on the rack, and pump some water into the lines, and them refill the reservoir a few times
+  - Let it stay in Standby Mode over night
+  - Syphon all the solution out
+  - fill back with Distill water, let it run through the lines, and syphon again. Do this step twice
+  - replace, the Di-filter, make sure to re tape the threads
+  - Fill back with distilled water, and fill the lines
+  - DONE FOR 6months
+{{:namespace:img_2823.jpeg?400|}}
+{{:namespace:img_0661.jpeg?400|}}
+{{:namespace:img_0668.jpeg?400|}}
+{{:namespace:img_0665.jpeg?400|}}